Did both firmware-updates for both camera-versions.
100B leads to 101c but i didnt document the update for 101f-camera.
it seems its for SDM-SX130IS-101f since it shows 100A.
Can you confirm that?
And i would like to know what were the different FW-versions of the cameras for. Thanks
there is now also a third FW-version: 101d!
cams with a Zero at 6th digit of SN. are updatable.
I was told 101d and 101f updates are already integrated in newer cams.
so if neigther 101c, 101d or 101f seen with ver.req or vers.req then it will lead to 101c always if its upgradable, 6h digit from left is "0"(zero).
Vers.req will tell.
Present your SDM setup like 3D rigs, KAP and Balloning equipment e.t.c
3 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest